top of page

For gluing furniture. Transparent after drying. Set quickly. Forms a moisture resistant elastic adhesive seam. Withstands high loads. Moisture resistant (moisture resistance class D3 according to EN 204 / D3). Does not contain organic solvents. For interior and exterior use.

Technical description:


Water, polyvinyl acetate dispersion, functional additives, preservative.


Milky white, colorless upon drying.


Approximately 1.0 g / cm3.


With a brush, roller, spatula.


Kaizer brand PVA Prof glue is designed for gluing wood products that are used in normal and high humidity conditions: windows, doors, furniture manufacturing, including kitchen and bathroom furniture, garden furniture, etc. Recommended for natural panel parquet, laminate, parquet flooring. Not suitable for bonding permanently underwater objects. For interior and exterior use.


Set quickly. White, transparent when dry. The glue joint can withstand temperatures from -30 ° C to + 80 ° C. Forms a moisture resistant elastic adhesive seam. Withstands high loads.

Substrate preparation:

The surface must be dry and sound. The surfaces to be glued must be cleaned of old peeling coatings, dirt, dust, grease and other substances that reduce adhesion. Sand shiny surfaces.

Application procedure:

Mix. Optimum temperature of air, material for gluing, glue + 15 ° C - + 20 ° C, wood moisture - 7 - 12%, relative air humidity 50-70%. At a lower temperature, the glue will set much longer. If the temperature is too high, moisture will evaporate too quickly, the glue will not have enough time to set, the strength of the glue joint will be low. When working in hot weather, apply the adhesive in small areas to reduce the risk of rapid drying and loss of adhesive properties. Wait until the material and the adhesive have reached the optimum temperature before gluing. The temperature of the room, the adhesive and the material, the air humidity, the quality and humidity of the material, the amount of adhesive applied strongly affect the setting and drying time, the strength of the adhesion.

Apply a thin layer to one of the surfaces to be bonded. A thick layer of glue is applied to soft woods, and a thin layer of glue to hard woods. When gluing: highly absorbent surfaces, hard woods (beech, oak, ash, tropical woods), apply the adhesive on both sides. Connect the parts, press and, no later than 6 minutes later, put under the press for 10-20 minutes. Wipe off excess glue that comes out of the seams.

Cleaning tools:

With water, immediately after use. Remove dried adhesive mechanically.


The guaranteed shelf life is 12 months from the date indicated on the package. Store and transport in original hermetically sealed containers at temperatures from +5 0С to + 35 0С.

Protect from moisture, heating devices and direct sunlight.


1 l, 5 l, 10 l.


Approximately 150-200 g / m2, depending on the absorbency of the substrate. The most accurate method of setting the flow rate is a test application.

Drying time:

Holding time under load - 10-20 minutes, pressure - 1-5 kg / cm² at 20 ° C and 50% relative humidity. The glued product is ready for use in 24 hours.

Processing temperature:

+ 10 ° C minimum for substrate and atmosphere during processing and drying.


Follow the general rules of occupational health. Work in work clothes, gloves. Keep out of the reach of children. In case of contact with eyes or skin, rinse with water, if necessary consult a doctor. The glue is non-toxic.


Dispose of dried adhesive and containers as household waste in accordance with local regulations.

Professional PVA glue - PVA Prof

0.3 Kilograms
    Логотип с белым фоном.png

    Наш адрес: Астана, ул. Абая 7, здание Строймарта, Отдел KAIZER 

    • 8 (701) 982-26-11

    bottom of page